|
|
OVERVIEW
The ISO 9151 equipment consists of a single meker burner
mounted on a stand so the position is easily changed from a
location to the side to directly under the material to be tested.
The burner and sample position are easily adjusted to meet the requirement of
ISO 9151 or to perform non-standard material testing.
The data acquisition unit consists of Measurement Computing 2416 logger and a
laptop to acquire the readings from the calorimeter and the position sensor
(Hall Effect sensor)
FEATURES
- Compact size – easily fits on a bench or in a fume hood 9spare requirements approximately 1 m x 0.6 m)
- Uses commercial propane (tank not included)
- Heat flux controlled by varying fuel pressure to burner
- Positive stop on burner arm – stops burner movement when it is positioned correctly under test specimen
- Easily calibrated – usually requires only one or two trials to achieve required heat flux
- Interchangeable calorimeters
- Calorimeters using wire type of either Type-J or Type-K
|
우) 01624 서울시 노원구 동일로 1700 파르코 317호
T: 02.949.7980 F: 02.701.7981 Copyright (C) 2017 S&T.
All Right Reserved.
